FR
IT
ES
EN
8. TROUBLESHOOTING
Problem
The SpO2 and pulse rate can not
be displayed normally.
The SpO2 and Pulse Rate are not
displayed reliably.
The device can not be turned on.
The display has turned off
suddenly.
The device can not be used for
full time after charging.
The battery can not be full
charged even after 10 hours
charging time.
9. KEY OF SYMBOLS
Symbol
DE
PT NL
SWE
Possible Cause
1. The finger is nor properly posi-
tioned.
2. The patient's SpO2 is too low to
be detected
1. The finger is not p`laced inside
deep enough.
2. The finger is shaking or the
patient is moving.
1. The battery is drained away or
almost drained away.
2. The malfunction of the device.
1. The device is damaged.
2. The battery is drained away or
almost drained.
1. The battery is not fully charged.
2. The battery is broken.
The battery is broken.
Refer to instruction manual/booklet
The pulse oxygen saturation (%)
Pulse rate (bpm)
Perfusion index (%)
The battery is full
Lack of battery power (please change batteries in time for exact measure).
Alarm sound indication off
Alarm sound indication paused
Alarm sound indication on
PL
DK
Solution
1. Place the finger properly and
try again.
2. Try again/Go to a hospital for a
diagnosis if you are sure the devi-
ce work properly.
1. Place the finger properly and
try again.
2. Let the patient keep calm.
1. Please recharge the battery.
2. Place contact the local service
center.
1. Please contact the local service
center.
2. Please recharge the battery.
1. Please recharge the abttery.
2. Please contact the local service
center.
Please contact the local service
center.
Description
Pulse oximeter
33