Broan Elite E60000 Serie Manual Del Usuario página 5

|
1.1
1.2
SELECT BLOWEROPTIONAND INSTALLATION TYPE
NON=DUCTED iNSTALLATiON
For a non-ducted installation,a recirculation kit ANKE60 Series (sold separately) must be installed. For maximum effectiveness,
we recommend installing this kit with a single (internal) blower hood. The kit fits hood from 30-inch width up to 48-inch
width. See installation instructions included with the non-duct kit ANKE60 Series.
DUCTED iNSTALLATiON
The Broan Elite E60000 Series range hood includes many configurations: Hoods with single or double internal blowers
(included with the hood), or hoods using external blowers. For this last category, the Broan Elite E60000 Series must be
installed with in-line blower models HLB3, HLB6, HLB9 or HLB11, or exterior blower model 331 H, 332H, 335 or 336 only.
Other blowers cannot be substituted. (Blowers sold separately).
Plan where and how the ductwork will be installed.
if installing in-line blower, refer to instructions packed with in=line blower and follow steps 1,2, 3, 4, 6, 10, 12 and
up of this manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. If using 7", 8" or 10"
round ducts, use a transition (internal blowers only). Use 2" duct tape to seal duct joints.
ROOF CAP
7" or 8" ROUND
bR 3W' x 10" DUCT
WALL CAP
7" or 8" ROUND
OR 3W'x 10"
t RECTANGULAR
ELBOW
24" TO 30" ABOVE
COOKING SURFACE
ONE iNTERNAL BLOWER
TYPICAL DUCTWORK
ROOF CAP
10"ROUND DUCT
WALL CAP
24"TO 30"ABOVE
COOKING SURFACE
41/2x 18_/¢'
10"
ROUND
TRANSITION
(see page 3)
TWO iNTERNAL BLOWERS
TYPICAL DUCTWORK
EXTERIOR BLOWER
10" ROUND
DUCT
10"ROUND
ELBOW
-XTERIOR
24" TO 30" ABOVE
COOKING SURFACE
332KR
ROUGH-IN KIT
(see page 4)
MODEL 331H, 332H, 335 OR 336
EXTERIOR BLOWER TYPICAL DUCTWORK
CAP
HH0091A
m
t HOOD
24" TO 30"
ABOVE COOKING SURFACE
WALL
CAP
m
MODEL HLB3, HLB6, HLB9 OR HLBll
IN=LINE BLOWER TYPICAL DUCTWORK
-5-