Installthe Blower; Installlightbulbs - Broan Elite E60000 Serie Manual Del Usuario

16. INSTALLTHE BLOWER
(EXTERIOROR IN-LINE BLOWER)
Refer to instructions included with blower.
Plug the 3-prong plug cord from rough-in plate to the 3-prong male
connector inside the hood (A) and the 2-prong male connector cord from rough-in
plate to the 2-prong plug inside the hood (B).
Do not plug the 2 cords together.
17. REINSTALLGREASEDRIP RAILAND BAFFLEFILTERS
Reinstall grease drip rail. The illustration at right shows how to reinsert the grease
drip rail into the range hood.
HD0244
\
Remove protective plastic film covering filters before installing them.
NOTE:Assemble the metal handles
to the filters, using provided
no. 8-32 x 1/4" screws, before
installing them in the hood.
It is recommended to install side
filters first and finish with center one(s).
1. Insert one end of the filter into the
upper channel of the hood.
2. Raise the other end toward the
inside of hood and insert in the
grease drip rail of the hood.
HD0245
18. INSTALLLIGHTBULBS
This hood requires 50 W, 120 V with GU10 base, shielded halogen bulbs (not included). (2 required for 30" and 36" hood widths
or 3 for 42" and 48" hood widths.)
Do not touch lamps during or soon after operation. Burns may occur.
In order to prevent the risk of personal injury, only install shielded
halogen lamps. Also, never install a cool beam, a dichro'fc lamp, a
pamp not suitable for use in recessed luminaires or identified for use I
lin enclosed fixtures, j
1. Install bulbs by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
HO0090
2
To remove bulbs, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
-12-