Publicidad
Idiomas disponibles
Idiomas disponibles
7
ENVIRONMENTALLY SAFE
BATTERY DISPOSAL
The toxic and corrosive materials below are in the batteries
used in this machine: Lithium-Ion, a toxic material.
WARNING
Discard all toxic materials in a specified manner to prevent
contamination of the environment. Before discarding
damaged or worn out Li-ion battery, contact your local
waste disposal agency, or the local Environmental
Protection Agency for information and specific instructions.
Take the batteries to a local recycling and/or disposal center,
certified for lithium-ion disposal.
WARNING
If the battery pack cracks or breaks, with or without leaks,
do not recharge it and do not use. Discard it and replace
with a new battery pack. DO NOT TRY TO REPAIR IT! To
prevent injury and risk of fire, explosion, or electric shock,
and to avoid damage to the environment:
•
Cover the terminals of the battery with heavy-duty
adhesive tape.
•
DO NOT try to remove or destroy any of the battery
pack components.
•
DO NOT try to open the battery pack.
•
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
•
DO NOT put these batteries in your regular household
trash.
•
DO NOT incinerate.
•
DO NOT put them where they will become part of any
waste landfill or municipal solid waste stream.
•
Take them to a certified recycling or disposal center.
8
INSTALLATION
8.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
English
•
If parts of the machine are damaged, do not use the
machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
8.1.1
ATTACH THE CARRYING RING
1. Pull carrying ring apart and place over power head end of
shaft; position near the power head.
2. Install bolt and lock nut.
3. Tighten nut securely.
Check for tightness before each use to avoid serious injury
or product damage.
7
WARNING
NOTE
EN
Publicidad
