Publicidad
Idiomas disponibles
Idiomas disponibles
8 OPERATING INSTRUCTIONS TIMER
a
c
d
PRODUCT DESCRIPTION
a Minute display
b Seconds display
c Start/pause button
d Minute setting button (MIN)
e Seconds setting button (SEC)
f RESET button
Use the Timer to set the timing (count-up and count-
down) as follows:
USE
Setting the count-up
Press the RESET button to set the display to 00:00.
Press the Start/Pause button to start or temporarily
stop the count-up.
During count-up, ":" fl ashes in the display.
Setting count-down with alarm
Press the RESET button to set the display to 00:00.
Press the MIN or SEC button to set the time. The Timer
can be preset to a maximum of 99 MIN 59 SEC.
Press the Start/Pause button to start or temporarily
stop the count-down.
When the time has elapsed, an acoustic signal sounds.
To switch off the alarm, press the Start/Pause button.
At the same time, the preset time appears again in the
display and can be started again by repeatedly press-
ing the Start/Pause button.
b
e
f
9 CLEANING INSTRUCTIONS
Wipe disinfection
To disinfect the device, a wipe disinfection with non-fl am-
mable, commercially available surface disinfectants (e.g.
Sani Cloth
Active from Ecolab Deutschland GmbH) must
®
be performed. When choosing a product for disinfection,
a disinfectant with appropriate ranges of action must be
used: bactericidal, yeasticidal, tuberculocidal and virucidal.
After the wipe disinfection, the products must be inspected
for visible contamination. If necessary, repeat the wipe dis-
infection. After the wipe disinfection, the products must be
checked in accordance with the section "Instructions for
use, 1 Device Check".
The device cannot be mechanically reprocessed or steri-
lised.
- 24 / 72 -
Publicidad
