Transportation of the product
•
Make sure that the Longopac bag is empty before a
transportation.
•
Make sure that the Longopac bag is attached to the
product during transportation.
•
Make sure that there is no leakage of dust during
transportation. The vacuum hose must be attached
to the inlet of the pre-separator tank and the inlet
plug must be attached to the inlet valve of the
primary tank.
•
Be very careful when you move the product up and
down ramps. The product is heavy and there is a risk
of injury if the product falls or moves too quickly. For
ramps with a large angle, always use a winch. Do
not walk or stay below the product.
•
Attach the product safely at the tie-down points
during transportation to prevent damage and
accidents.
•
Lock the caster wheels.
•
If possible, do the transportation of the product
during good weather conditions.
•
If possible, use a closed vehicle during
transportation of the product.
•
Let the engine become cool before you put the
product onto the vehicle. A warm engine and
exhaust system can burn you and ignition can occur
with some material.
•
During transportation, battery must be safely
attached and fully disconnected at all times.
Storage of the product T 4000 GP
Note:
Refer to the full generator operator's manual for
generator storage information that is not found here.
•
Put the product in an indoor storage away from
outdoor elements.
•
Lock the caster wheels.
•
Put the product in a dry and frost-free area where
the temperature is not too high.
•
Put the product in a locked area. Do not let children
or not approved persons near the product.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
Do not discard the battery as domestic waste.
•
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
20
Transportation, storage and disposal
2065 - 003 - 04.03.2024