HIKOKI N 1804DA Instrucciones De Manejo página 18

English
Maintenance chart
ACTION
Clean magazine
and feeder Prevent a jam.
mechanism.
Promote
Keep push lever operator safety
working and efficient
properly. Stapler
operation.
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
PROBLEM
Power switch doesn't turn on. Turn on
once, but turn off automatically.
Stapler doesn't operate (Power
switch ON).
Stapler operates, but no staple is
driven.
Weak drive.
Slow to cycle.
WHY HOW
Blow clean daily.
Blow clean daily.
CHECK METHOD
Low battery charge.
Damaged internal electronics.
Push lever and/or trigger is ON
state ?
Keep no operation over 30 minutes ?
(Auto-power off function)
Stapler not enough pressed against
workpiece.
Trigger not enough pulled.
More than 4 seconds pass from push
lever ON to trigger ON (or more than
2 seconds pass from trigger ON to
push lever ON).
Switch lock lever (Trigger lock
function) is "ON" position.
Machine is too cold (below -5°C) or
too hot. (LED light blinks at regular
intervals, and power switch goes off
after 10 seconds.) (Refer to page 14)
Damaged internal electronics.
Magazine is dirty.
Check for a jam.
Driver blade worn or damaged?
Feed spring weakened or damaged?
Staple feeder damaged?
Check for proper staples.
Check position of stapling depth
adjustment adjuster.
Driver blade worn?
Compressed air pressure has
become low.
Damaged internal electronics.
Charge the battery.
Contact HiKOKI for replacement.
Keep push lever and trigger in OFF
state.
Push and hold power switch more
than 1 second to switch "ON"
Hold stapler firmly and press to the
workpiece completely.
Pull the trigger firmly.
Make sure that less than 4 seconds
pass between push lever ON and
trigger ON (or make sure that less
than 2 seconds pass between trigger
ON and push lever ON).
Set Switch lock lever to "OFF"
position. (Refer to Fig. 9)
Allow the stapler to cool or warm-up
throughly in adequate condition.
Contact HiKOKI for replacement.
Blow and wipe clean the magazine.
Clear a jam (refer to Fig. 19, 20).
Contact HiKOKI for replacement.
Replace feed spring.
Replace staple feeder.
Use only recommended staples.
Readjust according to Fig. 15, 16.
Contact HiKOKI for replacement.
Contact HiKOKI for replacement.
Contact HiKOKI for replacement.
18
CORRECTION