Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION STEPS (For solder & blower function)
Release the trigger SLOWLY to extinguish the blue flame that
can be viewed in the hole.
Upon catalyst turning red, the
unit is ready to use for solder
or blower function. If blue
flame still appears in the hole,
remember to re-trigger again
to stop blue flame appearing.
REMINDER
It is important to follow the steps
mentioned above, otherwise plastic parts
of the product may melt.
TEMPERATURE ADJUSTMENT
Adjust the torch flame by turning the adjustment knob from left (-) to right.
For best result, adjust the length of the flame to approximately 1/2 to 1 inch.
(10 to 25 mm) in length when using. Do not make the flame of torch too
long, it will only waste fuel gas and make the flame unstable.
STORAGE
Before storing or leaving unattended, make sure the burner is switched off and the device has cooled
down. Store the device in a dry place out of reach of children and in the case provided.
CLEANING
Only clean the product with a dry or slightly damp cloth.
Never use aggressive cleaners such as petrol, brake cleaner, acid, etc. for cleaning.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Blue flame
in the hole
Blue flame
in the hole
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Re-trigger start
to extinguish flame
Plastic parts
melted
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
