Grohe SENSIA 36507SH0 Manual De Instalación página 15

Installing the ceramic
Remove the packaging from the ceramic.
Note
• Leave the packaging on the bottom part of the
ceramic until installation is finished.
Prepare and cut the water supply pipe and drainpipe
(supplied with the concealed cistern) to the necessary
length.
Attach the protection sheet to the wall.
Insert the water supply pipe and drainpipe.
Place the ceramic approximately 100 mm from the
wall. Then pull the power cord and the water supply
hose into the ceramic.
Secure the ceramic onto the wall.
Note
• Secure the ceramic using the hexagonal nuts
supplied with the concealed cistern.
Check whether the ceramic is horizontally flat.
Note
• If necessary, adjust the bowl horizontally by
loosening the hexagonal nuts in step
Remove the packaging under the ceramic.
Cut the protection sheet sticking out around the
ceramic.
Flush, confirm that there is no leakage in the pipeline.
Seal the edges where the protection sheet, toilet and
wall meet.
Insert the rubber expansion tube.
Installing the E-bidet
Thread the power cord and water supply hose.
Connect the power cord.
For the standard (36507SH0) model
Connect the water supply hose, and secure it with the
clip. Check if the water supply hose is properly
secured with the clip.
Note
• If the clip has not attached properly, remove it and
attach it again. To open the clip, insert a flat-blade
screwdriver and then press it downward and push it.
For the display (14533SH0) model
Attach the strainer.
Open the water valve to check for leakage.
For the standard (36507SH0) model
Twist the lever of the water supply hose vertically.
For the display (14533SH0) model
Thread the tube and place the E-bidet on top of the
ceramic.
11
GB
Install the E-bidet.
Put the E-bidet horizontally above the ceramic but
a bit more forward.
Move the E-bidet into place on the ceramic.
Push E-bidet back to install on the ceramic.
4
Open the toilet seat and lid.
5
Push the toilet seat and seat cover back carefully
to ensure the E-bidet is secure and the seat can
be lifted and rests in the correct position.
Note
• Ensure the E-bidet is fixed on the ceramic and
cannot flip-up.
6
Close the toilet seat and lid.
7
Remove the top cover.
8
Install set screws
9
Replace the top cover
Store the power cord in the groove on the bottom of
the bowl.
* The above does not always apply if, for some
reason, you cannot store the power cord in the
groove (e.g., the outlet is too far away).
.
Open the water shutoff valve.
For GROHE concealed cistern, adjust the amount of
flushing water using an adaptor valve (Item No.
42 333). Then reattach the actuation plate.
Turn on the power breaker.
Installing the remote control
Insert the batteries.
Choose an installation position for the remote control.
Mount the standard remote control holder onto the
wall.
Mounting the holder using screws
-1
-2
Attach the remote control to the holder.
Attach the label.
For plasterboard or plywood that is thinner
than 5mm
For concrete