Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow.
• Slide the battery compartment open.
• Remove the old battery and install the new one (CR2025) with the plus (+) sym-
bol facing up.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
CONTROLLED BY WIRED DMX
The fixture itself has 2-3.5MM audio and video sockets,through specialized DMX Cable can be con-
nect with DMX console. It must be set to DMX mode and Menu (W-DMX--Unlink RDX)
CONTROLLED BY WIRELESS DMX (transceiver not included. Available as an option: order WIDMX-T
(code: 15-1849))
Two modes: Guangzhou and Sweden
Guangzhou Wireless DMX
The operation method of fixture using Guangzhou wire-
less DMX as follows:
1. Firstly, set the fixture to DMX Mode
2. Secondly, set Menu (W-DMX) to Link RDX2
3. Thirdly, on the Menu (GROUP) set to any of groups 1 to 7. The colors are red, green, yellow, blue,
purple, cyan,and white.
The indicator light on the transmitter will show the same colour as selected above.
Sweden Wireless DMX
The operation method of fixture using Sweden wireless dmx as follows:
1. Firstly,set the fixture to DMX Mode.
2. Secondly, set Menu (W-DMX) to Link RDX1.
3. Thirdly, press wireless transmitter key to pair it with the fixtures.
MOUNTING ACCESSORIES
Small tripod
For a quick vertical setup, the tripod can be screwed onto the tube via one of its M8
threads. It can be folded for convenient transportation.
Rings
The ring can be screwed into the M8 thread on the battery tube.
SPECIFICATIONS
Power input : ....................................................................................................................100-240V~ 50-60Hz
Power : ..........................................................................................................................................................40W
LED: ....................................................................................... 128 x 0.25W RGBW 4in1,16 pixel zone control
3 Channel mode : ............................................................................................................................9/21/69CH
Control mode: .......................................... Master-slave, sound, auto, DMX 512, wireless, infrared remote
Power connector: ............................................................................................... DC 12.6-12.8V charging port
Battery .....................................................................................Lithium Ion Battery capacity: 12V 8000mAh
Charger ...................................................................................................................... output voltage: 12.6V 4A
www.afx-light.com
7
EN
Publicidad
