Publicidad
Idiomas disponibles
Idiomas disponibles
CUE and REVIEW can be used when fast forwarding or rewind-
playback.
ing through: short sections of the tape. CUE and REVIEW can
Press the FAST WIND
button corresponding to the direction
of.tape playback.
_RECORDING
@ The ALC (Automatic Record Level Control) circuit automat-
ically controls
the level of input signal
strength
used
for
recording.
u Radio
1 Tune in desired station. (See page 6.)
2
Load cassette into TAPE 2 cassette compartment.
3
Set TAPE switches for TAPE
2 to the proper position.
@ Turn the METAL selector off when using normal or chrome
tape. in TAPE. 2.
4 Set the REV MODE switch to &
when recording con-
tinuously from side A to B. Set it to
+
when recording only Ga
one side.
5 Press PAUSE button, then RECORD button, which also en-
gages PLAY button.
G set the BEAT CANCEL switch on the rear panel to A, B,
or C (whichever gives the best reception) when recording a
SW11 or SW2.
7
Press PAUSE button again to begin recording.
u Dubbing
my
[
1 Turn the power switch on.
3452.
1
6
2 set FUNCTION switch to TAPE.
3 Load recorded cassette into'cassette compartment of TAPE
1. Insert the blank tape into TAPE 2.
4 Set TAPE switches for TAPE 1 and 2'to the proper positions.
Hl:
@ Turn the METAL selector off when using normal or chrome
tape in TAPE 2.
5
Set DUBBING
SPEED switch to NORMAL
for equivalent:
speed dubbing, HIGH for double-speed dubbing.
6 Set the REV MODE switch to
&2
when dubbing continu-
ously from side A to B. Set it to.
++
when dubbing only one
side.
:
:
:
i
7 Press DUBBING START. The PLAY button of Tape 1, PLAY
and RECORD buttons of TAPE 2 will be automatically engaged.
7
@ Do not change the setting of the DUBBING SPEED switch
during dubbing.
@ Do not connect any plug to the MIC socket during dubbing.
[E]10
Publicidad
