Eaton TRIPP LITE Serie Instalación página 2

Installation
Instalación / Installation /
Installation / Installazione
Notes:
• Test to make sure the entire installation works properly before pulling cables through ceilings/walls.
• The B122-000-60 and B122-000-4K6 have been designed for use with P568-Series HDMI cables. To ensure
maximum distance and performance, it is recommended that you use P568-Series HDMI cabling. For
distances over 75 ft. (23 m), 24 AWG cable such as P568-100-HD is required.
• Although most installations will not require power, a Micro USB port is provided in the event power is needed.
If an image does not appear after performing the following steps, connect a Micro USB cable from the port on
the unit to a USB computer, monitor or USB wall charger, such as U280-002-W12.
Monitor
1. Connect the longer HDMI cable between the source and the SOURCE port on the B122-
000-60 or B122-000-4K6.
the source to the B122-000-60 must be no longer than 125 ft. (38 m).
2. Connect the shorter HDMI cable between the HDMI monitor and the DISPLAY port on the
B122-000-60 or B122-000-4K6.
60 or B122-000-4K6 must be no longer than 16 ft. (5 m).
2
23-09-092-93-4983.indd 2 23-09-092-93-4983.indd 2
Note: When transmitting a 1080p (60 Hz) signal, the HDMI cable connecting
Note: The HDMI cable used to connect the monitor to the B122-000-
Blu-Ray
2/26/2024 3:22:05 PM 2/26/2024 3:22:05 PM