Completely assembly the mistblower before its first use:
4.1 Installation of pleated elbow tube
Fig. 4
4.2 Install multi-function handle and blower tube
Fig. 5
4. Assembly
Remove screws A and B.
Push pleated elbow tube (16) into the opening of the blower
housing (20) until resistance is felt and re-tighten screws A and B
to hold tube in place.
Note: Ensure the pleated elbow tube can be easily swiveled after
fitting it to the blower housing.
Push multi-function handle onto blower tube and fix
with 2 screws in the required, comfortable position. The
adjustment scope is approx. 50mm depending on the
arm length of the operator.
Push blower tube into pleated elbow tube (1.16) and
secure with plastic clamp (C).
Note: With the multi-function handle the blower tube
can now be twisted and swiveled in the pleated blower
elbow. Ensure that no cables are disconnected when
testing this feature.
• Insert extension tube 2 in blower tube 1 and secure
with twist lock
• Push curved nozzle tube on extension tube and also
secure with twist lock
Assembly
ENGLISH
9