Fuel Filter; Air Filter; Starter Unit; Engine - Efco DS 2200 Manual De Instrucciones

contact a Servicing Dealer for adjustment
and discontinue use until the repair is made.
• Screw L must be adjusted so that the engine
promptly responds to sharp accelerations
en
and gives good idle operation.
• Screw H must be adjusted so that the
engine gives maximum power during the
cutting phase.

Fuel Filter

Check the fuel filter (Fig. 22) periodically.
Replace it if contaminated or damaged.

Air Filter

WARNING: Do not clean filter
in gasoline or other flammable
solvent to avoid creating a fire
hazard
evaporative emissions.
If a power drop is noticed, check the air filter.
Open the air filter cover (A) and check the air
filter (C, Fig. 23) each day, change the filter if
heavily clogged or damaged.
DS 2200: Clean with Emak degreaser p/n
001101009A, rinse with water and blast dry
with compressed air.
DS 2400: Clean with Emak degreaser p/n
001101009A, rinse with water and blast dry
with compressed air, not too close, blowing
from the inside outwards.
Reinstall the air filter into cover. Place the air
filter cover onto the brush cutter. Tighten the
air filter cover screw (B) securely.
A used air filter can never be completely
cleaned. It is advisable to replace your
air filter with a new one after six month of
operation.
Make sure the cover and the support are
clean before fitting the new filter.
28
or producing harmful
MAINTENANCE
CAUTION: Never run the engine
without the air filter, serious
damage could result.
Make sure the air filter is correctly
placed in the air filter cover before
reassembly.
Always replace damaged filters.
Do not clean a filter with a brush.

Starter Unit

WARNING: The coil spring is
under tension and could fly apart
causing serious injuries. Never
try to disassemble or modify it.

Engine

Clean the cylinder fins with compressed air or
a brush periodically. Dangerous overheating
of engine may occur due to impurities on the
cylinder.
WARNING: Never run the machine
without all the parts, including
the starting housing, securely in
place.
Because parts can fracture and
pose a danger of thrown objects,
leave repairs to the flywheel and
clutch to trained Servicing Dealers.

Spark Plug

This engine uses a NGK CMR7H with .02"
(0.5 mm) electrode gap. Use an exact
replacement and replace every six months or
more frequently, if necessary.