Assembly; Loop Handle (Ds 2200 Tr); Assembling The Bike Handle (Ds 2200 T - Ds 2400 T); Assembling The Cutting Attachment Guard - Efco DS 2200 Manual De Instrucciones

WARNING: The muffler and other
parts of the engine (e.g. fins of
the cylinder, spark plug) become
hot during operation and remain
hot for a while after stopping the
engine. To reduce risk of burns
do not touch the muffler and other
parts while they are hot.
Loop handle (DS 2200 TR) (Fig.26)
Loosen the wing nut (A) and rotate the loop
handle (B) of 180°.
Assembling the bike handle
DS 2200 T
- Place the bike handle (A, Fig.4) in the lower
hub (B1).
CAUTION: The bike handle (A)
must be fixed onto the hub
(B) inside the two notches (C)
indicated on the bike handle.
- Place the upper hub (B2) in position and
tighten the 4 screws (D), without finally
tighten yet.
- Line up the handlebar at a right angle to the
drive tube.
- Tighten down the screws (D) firmly.
DS 2400 T (swivelling bike handle)
- Release the wing screw (E, Fig.5) and
unscrew it until the bike handle (F) can be
turned anti-clockwise.
- Turn the handlebar 90° and then swing the
handles up.
- Tighten down the wing screw (E) firmly.
Storage or transportation positions
- Reverse the sequence described above
to swing the handles up and turn the bike
handle clockwise.
Mounting the control handles (DS 2200 T
– DS 2400 T)
- Loosen the screw (G, Fig.6). The nut (H)
remains in the control handle (L).
- Push the control handle (L) (throttle trigger

ASSEMBLY

M must point toward the gearbox) onto the
bike handle (N) so that the holes (P) line up.
- Insert screw (G) and tighten down firmly.
WARNING:
handlebar be careful to avoid the
cables getting twisted.

Assembling the cutting attachment

guard
(Fig. 7) (DS 2200T - DS 2400 T)
- Insert the two pins (E) of the cutting
attachment guard, in the holes (F).
- Assemble the guard (A) to the gearbox with
screws (B) and washers (G) in a position
allowing the operator to work safely.
NOTE: assemble the skirt (C) only when
using the nylon heads. Secure the skirt
(C) to the protection (A) by means of the
screw (D).
WARNING:
cutting attachment without an
approved guard. See the section
on
attachments
incorrect or faulty guard may lead
to serious personal injury.
WARNING: The deflector provided
with your brush cutter may not
protect the operator from all
foreign objects (gravel, glass, wire,
etc) thrown by the rotating cutting
attachment.
may also ricochet and strike the
operator.
WARNING: Immediately replace a
broken or damaged guard; never
try to mount the guard in incorrect
position.
Assembling the cutting attachment
WARNING:
cutting attachment it is extremely
important that the drive flange
engages correctly in the centre
hole of the cutting attachment. If
the cutting attachment is fitted
incorrectly it can result in serious
and/or fatal personal injury.
In mounting
Never use
Recommended
(Page 10).
Thrown
When fitting
the
en
a
cutting
An
objects
the
13