Publicidad
Idiomas disponibles
Idiomas disponibles
EN
grounding clamp. If plastic pipe is used in your
home, a qualified electrician should install
a proper ground.
Attaching discharge elbow
1. Connect the waste elbow to the disposer
by sliding the flange against the rubber
gasket on the elbow and tightening the
screws into the disposer (fig. 4A).
2. Connect bottom of the elbow by tightening
the slip nut (fig. 4B). If using a straight pipe,
it must have a lip similar to the one on the
elbow.
3. Remove the gasket from the elbow and
install it on the straight pipe with the flat end
of the gasket facing toward the disposer
discharge opening.
Rubber
gasket
4A
4. If you are connecting to a dishwasher, return
to Plumbing connection section (fig. 2A-B).
If not, make sure all plumbing connections
are tight and in accordance with all plumbing
codes and ordinances.
5. Run water and check for leaks.
Air switch operated
Disposer Air Switch Assembly
The Actuator which consists of:
1. Actuator Button
2. Actuator Nut
3. Actuator Outlet (threaded portion)
The Air Switch Sensor Enclosure which is
installed into the disposer. Only the air tube
nozzle is visible from the outside of the
disposer.
Air Tube Assembly which consists of:
4. Air Tube - clear or black
5. Air Tube Nut
FWDS50 / FWDS75 / FWDS75BF / FWDS100 / FWDS125
4B
P-trap
5
Installation and operating instructions
1. If a hole does not already exist - drill a hole of
35 mm to 40 mm into the sink or countertop
where the actuator button (1) is to be placed.
2. Insert, from the top, the actuator outlet
through the drilled hole.
3. Thread the actuator nut (2) onto the actuator
outlet (3) and tighten firmly by hand.
4. Firmly connect air tube: one side to actuator
outlet (3) and one side to sensor inlet.
5. Plug disposer power cord into main
electrical service.
6. To turn on disposer, press actuator button (1).
To turn off, press actuator button again.
Mounting Magnetic Rim to sink flange
(if equipped)
1. After the disposer is fully mounted to the
sink; with the flat portion of the black strap
facing the metal sink flange, guide the
Magnetic Rim through the mount screws,
(fig. 6A).
2. Place the Magnetic Rim between the
support flange and upper mounting ring.
Please note (fig. 6B) that the Magnetic Rim
must be placed under the flange of the
support ring.
3. Once the Magnetic Rim is fitted, firmly press
on the snaps to secure the strap (fig. 6C).
6A
12
1
2
3
4
5
Publicidad
