Franke FWDS50 Manual De Instalación Y Servicio página 15

3. If reset button has not been tripped, check
for shorted or broken wire connecting to
disposer. Check electrical power switch,
fuse box or circuit breaker. If wiring and
electrical components are intact, the unit
may have internal problems that require
service or replacement.
If turntable does not rotate freely:
1. Turn off disposer, then check for any foreign
object lodged between the turntable and
grind ring.
2. Dislodge object by rotating table with a
wooden broom handle and remove object
(fig. 7). If no foreign object is present, there
may be internal problems.
Leaks: If the unit leaks at the top, it may be due to:
– Improper seating of sink flange (gasket
centering, putty or tightening).
Cleaning and maintenance
Do not attempt to lubricate your disposer!
The motor is permanently lubricated. The
disposer is self cleaning and scours its internal
parts with each use. Never put caustic soda or
chemical drain cleaners, as hydrochloric and
muriatic acid, products for unclogging the sink
drain, into the disposer, as they cause serious
Disposal
The symbol on the product or on the
packaging indicates that the device
must not be disposed of in the domestic
waste.
By disposing of the device in a proper way you
help to avoid harmful consequences to
environment and health.
Further information about recycling the device
is available from the competent authority, the
local refuse disposal service or the vendor of
the device.
Dispose of the device, which is to be
discarded, via a specialised waste collection
point for electronic and electrical devices.
FWDS50 / FWDS75 / FWDS75BF / FWDS100 / FWDS125
– Support ring not tightened properly.
– Defective or improperly installed cushion
mount.
If unit leaks at the waste elbow, leak may be due
to improper tightening of elbow flange screws.
7
corrosion of metal parts. If used, resulting
damage can be easily detected and all
warranties are void. Mineral deposits from your
water can form on the stainless steel turntable,
giving the appearance of rust. Do not be
alarmed, the stainless steel turntables used will
not corrode.
Consequently, when the appliance has reached
the end of its working life the user must take it
to a suitable recycling center for electronic and
electrotechnical waste, or return it to the dealer
when purchasing a new appliance of equivalent
type.
Proper separate waste collection of the
scrapped appliance for subsequent recycling,
treatment and environmentally-friendly
disposal helps prevent a potentially negative
impact on the environment and health and
facilitates recycling of the materials used in
appliance construction.
The food waste disposer is for domestic use
only.
15
EN
Remove
splash guard
Turntable