Publicidad
Idiomas disponibles
Idiomas disponibles
2A
Installation of mounting assembly
3
Sink
FWDS50 / FWDS75 / FWDS75BF / FWDS100 / FWDS125
Knock out plug
Wood or metal dowel
Removable
Splash Guard
Sink Flange
Plumber's Putty
(not included)
Groove
Flat Gasket
Support Flange
Upper Mount Ring
Mounting Screw
Retainer Ring
Cushion Ring
Lower Mount Ring
Magnetic Rim
Elbow Flange &
Screw Set (2)
Elbow
WDJ-XXX
Reset Button
2B
*Air gap may not be required for all
installations. Check local plumbing
codes.
Note: The mounting components are assembled
out of the box in the same order they will be
assembled on the sink, so please pay close
attention to the order of the mounting system
components before you disassemble them.
1. The cushion ring and the lower mounting
ring will remain attached to the disposer
during installation. Disassemble the other
components of the mounting assembly by
rotating lower mounting ring clockwise until
the lower mounting ring tabs slide off from
the upper mounting ring ramp. This will allow
you to separate the upper assembly from
the remaining lower mounting assembly.
2. Unscrew the 3 mounting screws until the
upper mounting ring can be moved to the
top of the support flange. Remove the
retainer ring with a screw driver.
3. Keep the remaining parts placed together in
the order they were removed. Before you
connect the disposer to the mounting
assembly under the sink, make sure the
lower mounting ring is in place and the black
cushion ring is still engaged properly to the
top of the disposer opening. Do not remove
the cushion ring.
4. Be sure the sink is clean. Install a bead of
plumbers putty to the sink flange (1). From
top of the sink, push the sink flange down
against the sink opening to make a good
seal (2). Do not move or rotate the sink
9
*Air gap
Rubber Hose
Dishwasher Hose
Drain
Disposer
EN
Publicidad
