Publicidad
Idiomas disponibles
Idiomas disponibles
Sanding tips
• If the tool is connected to a vacuum dust extraction system, switch the extraction device on before
switching on the sander. Switch the sander off first, then the vacuum system
• Move the machine in a circular motion over the workpiece surface, applying an even, moderate
pressure until you reach the desired surface finish
WARNING: Excessive pressure does not lead to a faster removal of material; it will lead to
premature wear of the sanding sheet and may cause damage to the tool. Both sanding performance
and quality depend mainly on the choice of the correct sanding sheets.
• If there are still scratches on your workpiece after sanding, refer to 'Selecting the right grade of
sanding sheet'
Accessories
• A full range of sanding sheets and accessories is available from your Silverline stockist
Maintenance
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild detergent
on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes (where
applicable)
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
De Keten
00004
5651 GJ
Eindhoven, Netherlands
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Hook & loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter, such as hair, fibres,
sand etc.
• In order to provide adequate adhesion for securing accessories, hook and loop surfaces must
be in good condition
• When used extensively, hooks and loops will become elongated or broken, and the mechanism
cannot provide the required strength of adhesion anymore
Note: This sander's hook and loop sanding base is NOT a warranty item. Replacement plates can be
fitted at an authorised Silverline service centre.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
180W Detail Sander
7
Publicidad
