Publicidad
Idiomas disponibles
Idiomas disponibles
- The battery must not be empty. An
empty battery is shown in the display
by the battery symbol
2
- If a definitive measurement is not possible,
the display shows the „Err" information.
The measurement must then be repeated.
Addition of distances
With the product you can add the meas-
ured distances together:
1. Measure the first distance as described
in the section „Measuring distances".
2. Press the + / = button
sage „+" appears in the display
and the measured distance in the
row below.
3. Measure the next distance. The new
distance measured is shown in the
upper row of the display.
4. Press the + / = button again. The new
measurement is added to the old in
the lower row.
5. Repeat steps 3 to 4 to add further
measurements.
6. Press the MODE button
the addition mode. All the measure-
ments will be deleted.
Measuring
surface areas
1. Slide the function switch
position „DISTANCE". The display
is turned on.
2
44 GB/IE
.
. The mes-
12
to leave
4
to the
9
2
Publicidad
