Powerfix Profi 285131 Instrucciones De Utilización Y De Seguridad página 46

8. Repeat steps 2 to 7 to add further
measurements.
9. Press the MODE button
the addition mode. All the measure-
ments will be deleted.
Measuring volumes
1. Slide the function switch
position „DISTANCE". The display
is turned on.
2
2. Press the MODE button
message „L" (length) appears in the
display.
3. Press the READ button
the length. The measured length ap-
pears in the upper row of the display
and the message „W" (width) starts
to blink.
4. Press the READ button to measure the
width. The measured width appears
in the upper row of the display and
the message „H" (height) begins to
blink.
5. Press the READ button to measure the
height. The measured height appears
in the upper row of the display. The
results of the volume calculation ap-
pear in the lower row.
Addition of volumes
1. Measure a volume as described in the
section „Measuring volumes".
46 GB/IE
to leave
4
to the
9
twice. The
4
to measure
6