DJI D12000iEP Guía De Usuario página 13

Replacing the Engine Oil
• Contact a DJI-authorized dealer or DJI Support to replace the engine oil.
1. Place the generator on a flat surface. Start the generator to warm
up the engine for several minutes and then stop the generator.
2. Place a container under the engine oil drain hose.
3. T a k e d o w n t h e e n g i n e o i l d r a i n h o s e a n d r o t a t e t h e c a p
counterclockwise to open. Wait for the oil to drain completely.
4. Install and secure the engine oil drain hose back in place. Rotate the
cap clockwise to tighten it.
5. Unscrew the dipstick and use the engine oil funnel to add the SJ
10W-40 engine oil (or equivalent) to the upper limit. Put the dipstick
back in and screw tight.
• Engine oil significantly affects the engine performance and is the main factor that determines
its service life. It is recommended to use oil intended for four-stroke car engines and that
meets or exceeds SJ standards according to the API classification. Normally, the API grade
is shown on the package of engine oil bottle. Make sure it says SJ or a higher grade. The
recommended engine oil type is SJ 10W-40.
• To prevent damage to the environment, it is recommended to seal used engine oil in a
container and hand it over to a dedicated recycle center. DO NOT dispose of used engine oil
in normal household waste, on the ground, or down a sewer drain.
Checking and Cleaning the Air Filter Element
1. Remove the cover of the air filter and take out the sponge filter
element. Clean the sponge filter element thoroughly with normal
cleaning agent or warm water and let it dry under the sun. Clean
the dust in the filter housing, and use a carburetor cleaning agent to
clean the engine oil in the cover and wipe it dry.
2. Check whether the paper filter element surface becomes wet with
engine oil. If the paper filter element is wet with engine oil, contact
a DJI-authorized dealer or DJI Support to replace the paper filter
element. If it is not necessary to replace the paper filter element,
tap it gently on the ground to shake off any dust and debris. Clean
the dust in the filter housing, and use a carburetor cleaning agent to
clean the engine oil in the cover and wipe it dry.
3. Install the paper filter element and the sponge filter element into the air filter, and install the cover
back in place.
• Replace the sponge filter element if it is damaged during cleaning.
• DO NOT use an air blower or compressed air to clean the paper filter element as it may cause
damage to the intake pores of the element.
Cleaning the Spark Arrestor
1. Use a screwdriver to remove the four screws and the protective
cover. Take out the spark arrestor.
2. Inspect the spark arrestor. Wash it with a carburetor cleaning
agent and descale it with a wire brush. Replace it if it is broken.
3. Install the cleaned or a new spark arrestor and tighten the screws.
12
Paper Filter Element
Sponge Filter Element