cecotec ENERGYSILENCE AERO 7000 LIGHT PRO Manual De Instrucciones página 46

ENGLISH
11. If you have chosen the pre-installed downrod, remove the pin and continue from step 15. If
you have chosen the extension downrod continue with the following steps.
12. Remove the pin, the hanging ball screw together with the downrod and the other pin.
13. Place the hanging ball, secure it with the pin and screw it in place. Do not put the pin that
is not in the hanging ball yet.
14. Pass the canopy and the downrod cover through the downrod you have chosen to use,
Fig. 15
15. Loosen the motor screws to connect the fan body to the downrod.
16. Route the motor cables inside the downrod.
17. Screw the motor back onto the downrod.
18. Slide the downrod cover towards the motor body.
19. Hang the fan body from the hanging ball to the bracket, make sure it fits snugly and connect
the receiver plugs together with the motor plugs.
20. Place the receiver of the remote control on the mounting bracket Fig. 18
21. Now place the blades into the side holes of the motor and screw them tightly Fig. 19
22. Screw the light bracket onto the bottom of the engine Fig. 20
23. Place the LED light inside the bracket which is held in place by magnets.
24. Place the lampshade and turn it until it is secure.
25. Before starting the fan, it is important to make sure that the fan blades are secure.
4. OPERATION
Fig. 13 key:
1. Operation indicator light
2. Fan off button
3. Fan on and speed buttons (1 to 6). You can switch on the fan at the desired speed
4. Light on/off button
5. Natural breeze button. The fan chooses speeds from 1 to 6 randomly
6. Winter/summer button.
7. Timer buttons
- Only use the button to select Natural Breeze
- If you press any timer button
otherwise the function will be cancelled.
- For light operation
also change the temperature of the light in a cyclical manner.
NOTE
- If you notice that the transmitter does not control the receiver, check that the batteries are
inserted correctly and that they are not dead.
46
ENERGYSILENCE AERO 7000 LIGHT PRO
.
.
, pressing the button successively will turn the light on and off. It will
.
when the fan is in operation.
, do not press any other button,
.