Publicidad
7 Assembly Procedure
1 1 1 1 1
Attach an nut with spring washer (M8) 6 to each special
eye bolt 2. Insert them in the specified holes and fix
them with flat washers (small) 3 and nuts (M8) 5. (For
safety reasons, use 2 nuts for each special eye bolt.)
Attach the nuts (M8) in the way illustrated below to pre-
vent the special eye bolts from loosening.
1. Insert the special eye bolt in the PDP bracket
together with an nut with spring washer (M8).
(2 locations: left and right)
2
6
Hexagonal nut with spring
washer
Secure the nut as
close to the root of
the bolt as possible.
3. Tighten the nuts with a spanner.
Side where pipes protrude
longer is the top.
View from the bottom
4. For safety reasons, use 2 nuts on
the bottom (tightening them so
that they engage each other).
Caution
Use the special eye bolts only in the specified
places. Do not use them on the plasma dis-
play itself, which could be damaged internally
by them.
2. Pass the bolt through both then use a
flat washer (small) and a nut to fixate
it from the bottom.
5
3
5
7
En
Publicidad
