Publicidad
2 2 2 2 2
With the screen facing down, place the plasma display on the top of a level and stable table, as shown in the figure.
Be sure not to drop or damage the display.
3 3 3 3 3
Place flat washers (large) 7 in the specified places (4 places) on the plasma display, then fasten them from above with the
monitor mounting bolts 4. The part of the PDP bracket where the pipe protrudes the furthest is on top.
4 4 4 4 4
Attach the PDP bracket to the fixed monitor mounting bolts 4.
Make sure to attach the washers. Using the same
number of washers in the same positions will pre-
vent the display from being crooked.
Caution
5 5 5 5 5
Lastly, fix the nuts with spring washers 6.
7 Application example
These can be used as handles to transport or to install the plasma
display as shown in the figure. With the PDP bracket mounted,
Pioneer's standard CEILING MOUNT UNIT (PDK-5012) can be attached
(excluding wall hanging hardware (PDK-5011, PDK-5013)).
8
En
6
4
7
[Top and bottom of the PDP bracket]
The top is the side where
the pipe protrudes more.
The bottom is the side where
the pipe protrudes less.
PDP bracket
4
6
7
Publicidad
