1.- Player module information display.
2.- Player buttons.
a.- MODE: short presses of this button allow you to change the
mode on the player to choose the desired audio source: USB,
microSD (CArD), Bluetooth (BLUE), FM radio (display shows
frequency), line-in (LINE).
1
REC: a short press of this button starts/stops the recording
b.-
of the microphone audio. A long press allows the recorded
tracks to be played back. Once you have started playback, you
2
can control it with the buttons
c.-
: in Bluetooth, USB and micro SD mode,a short press will skip to the previous song and a press
3
in FM mode will skip to the previous stored frequency.
d.-
: in Bluetooth and USB and micro SD mode, starts/pauses audio playback; in FM mode, it
4
automatically memorises all frequencies detected with sufficient signal quality.
5
e.-
/TWS: in Bluetooth, USB and micro SD mode, a short press allows you to skip to the next song.
In FM mode, switches to the next stored frequency. A long press on this button activates the TWS
6
function, for more information see OPERATION.
f.-
: in USB and micro Sdmode,mode, activates/deactivates shuffle playback.
7
-
ONE: plays the same song over and over again.
8
-
ALL: plays the songs in order and restarts at the end.
9
g.- EQ: allows you to select between the different existing equalisations: FLAT (no EQ), POP, ROCK,
JAZZ, CLASSIC.
h.- VOICE CANCELLER: removes the voice from songs by equalizing to enhance the karaoke
experience. The display shows rON when the function is activated and rOFF when it is deactivated.
i.-
MIC PRIORITY: activate microphone priority over music. The music will fade out when there is
a signal from either microphone: MIC 1, MIC 2 or wireless microphones. The display shows PON
when the function is activated and POFF when it is deactivated.
j.-
FOLDER: in USB and microSD mode, allows you to select the folder to be played.
3.- PLAYER VOL: player volume control.
4.- TREBLE: control that boosts or attenuates the player's treble frequencies.
5.- BASS: control that boosts or attenuates the player's bass frequencies.
6.- ECHO: control of the echo function on the microphones. Allows adjustment of the number of echo
repeats of MIC 1, MIC 2 and wireless microphones.
7.- TREBLE: control that boosts or attenuates the high frequencies of the microphones MIC 1, MIC 2 and
wireless microphones.
8.- BASS: control that boosts or attenuates the low frequencies of the microphones MIC 1, MIC 2 and
wireless microphones.
9.- MIC VOL: microphone volume control MIC 1, MIC 2 and wireless microphones.
10.- GUITAR: guitar input, 6.3 mm mono jack plug.
11.- LINE IN: stereo line-level auxiliary input, 3.5 mm jack plug.
12.- MicroSD memory card connection port.
13.- USB storage device connection port.
14.- LINE OUT (PLAYER): mono auxiliary output of the player's signal, RCA connector.
15.- MIC 1, MIC 2: balanced mic level input, 6.3 mm jack plug.
16.- CHARGING BATTERY: battery charging process indicator light. This indicator will illuminate blue while
the battery is charging and will turn green when the battery is fully charged.
17.- Input to connect AC power supply cable.
18.- On/off loudspeaker switch.
MALIBU-312
,
and .
10
11
12
13
14
15
16
17
18
- 3 -
a
b
c
d
f
g
h
i
EN
e
j