Publicidad
Idiomas disponibles
Idiomas disponibles
TWS FUNCTION (TRUE WIRELESS STEREO)
The TWS function allows the player's audio (USB, microSD, Bluetooth, FM or AUX) to be played through
2 speakers in stereo. For this function there will always be a master speaker playing the left channel of the
stereo signal, and a slave speaker playing the right channel.
To do this you must have 2 MALIBU-308, MALIBU-310, MALIBU-312 or MALIBU-315 speakers and follow
these steps:
1.- Turn both MALIBU speakers on and activated Bluetooth mode.
2.- On the slave speaker, press the TWS button and SLAU will both show and flash on the display..
3.- Wait a few seconds, the displays on both speakers will stop flashing indicating that they are connected.
4.- Select the playback mode on the master speaker and start playback.
Both speakers can be used to control the player's functions: , ,
to switch modes from the master loudspeaker.
NOTE: all other speaker inputs such as MIC or GUITAR will only be heard through the speaker to which
they are connected. Please note that if the wireless microphones of both loudspeakers are of the same
frequency, both cannot be used.
CONNECTION AND OPERATION
- Before making any connections:
- Make sure that all equipment is switched off and disconnected from the power supply socket.
- Check the condition of the speaker battery and the wireless microphone batteries.
- Set the volume controls to minimum.
- Connect the device(s) you need:
- USB device in the USB port.
- MicroSD card in the microSD slot.
- PC, tablet, smartphone, etc. in the LINE IN input.
- Microphone cable in inputs MIC 1 and MIC 2.
- For Bluetooth mode you will have to wait for the speaker to turn on and pair it.
- Turn on the devices connected in the previous step and the wireless microphones, and lastly, turn on
the loudspeaker. You can use the MALIBU powered directly from the mains or using the internal battery.
- Select the operating mode and adjust the PLAYER VOL and MIC VOL volume controls.
NOTE: if a microphone (wireless and/or wired) is to be used, be sure not to stand in front of the loudspeaker
and at a distance to avoid feedback and other disturbing noises.
- After use, do not forget to switch off and disconnect the equipment from the mains.
- 7 -
and . But it will only be possible
EN
Publicidad
