REMOTE CONTROL
1.-
: mutes the speaker.
2.-
MODE: short presses of this button allow you to change the mode
on the player to choose the desired audio source: USB, microSD
(CArD), Bluetooth (BLUE), FM radio (display shows frequency),
line-in (LINE).
3.-
REC: a short press of this button starts/stops the recording of the
microphone audio. A long press allows the recorded tracks to be played
back. Once you have started playback, you can control it with the buttons
,
and .
4.-
/ : in Bluetooth, USB and micro SD mode, starts/pauses audio playback;
a long press to fast forward/rewind. In FM mode it skips to the previous/
next stored frequency.
5.-
: in Bluetooth, USB and micro SD mode, starts/pauses audio playback;
in FM mode, it automatically memorises all frequencies that are detected
with sufficient signal quality.
6.-
: in USB and micro SD mode, activates/deactivates shuffle playback.
-
ONE: plays the same song over and over again.
-
ALL: plays the songs in order and restarts at the end.
0-9: number buttons to automatically select the desired audio track on the USB or microSD device or
7.-
the stored radio station. In FM radio, allows to select the stations stored in the memory.
8.-
TWS: A press on this button activates the TWS function, for more information see OPERATION.
VOL -/VOL+: player volume controls.
9.-
10.- EQ: allows you to select between the different existing equalisations. FLAT (no EQ), POP, ROCK, JAZZ,
CLASSIC.
OPERATION
RECHARGEABLE BATTERY
To charge the battery, connect the device to a 230 V AC socket using the mains cable. Keep the device
connected to the mains and switched on during the charging time, which is approximately 3 hours. The
battery indicator light will turn blue during charging and will turn off when fully charged.
Battery life depends on the use of the equipment, type of music played, volume, etc. Battery life is 16 hours
under optimal laboratory conditions.
NOTE: this speaker is battery operated and connected to AC power.
PLAYER
All player modes have additional equalisation to the rear panel controls (BASS and TREBLE) via the EQ
button on the player and on the remote control. In addition, the remote control has a MUTE function to mute
the audio (the display will flash indicating that the mute function is active).
USB/microSD MODE
- Insert the USB device or microSD card and select the desired mode; the display will show USb or CArD
respectively. It will then start playback by indicating the song number, briefly, and the playback time
(00:00).
- Press / , on the player or on the remote control, to change songs or to
NOTE: this mode allows you to change the playback mode.
- 5 -
1
2
3
4
5
6
7
pause/resume playback.
EN
8
9
10