Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
Reverse lever
2
Housing, chrome finish
3
Calibration screw,
do not turn without calibration machine
4
Base scale Nm
SETTING TORQUE WRENCH
1. Balance the wrench in your left hand and unlock knurled handle by turning locking knob anti
clockwise.
2. Set torque amount by turning knurled handle (see example 9.6 Nm).
a) Turn the handle until you reach 0 on the fine scale and 8 on the main scale.
Set value = 8 Nm
b) Now continue to turn the handle until you reach 16 on the fine scale. Please note that one line
on the fine scale corresponds to 0.1 Nm.
c) Set value = 8 Nm + (16 x 0.1 Nm) = 9.6 Nm
3. Lock the handle by turning the locking screw clockwise.
4. Install the proper socket or attachment to nut or bolt and pull handle until you feel and/or hear the
wrench click.
5. Setting of m/kg is done in the same way as above.
EXAMPLE
2 Nm
WARNING
•
Do not pull after the wrench clicked. Use special care at low torque settings.
•
When not in use, keep lowest torque setting.
•
Only turn the knurled handle between the specified lowest and highest torque value.
•
Your torque wrench is a precision measuring instrument and should be treated as such.
•
Do not attempt to turn the grip while it is locked.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
5
Base scale m/kg
6
Locking knob
7
Square drive
8
Handle with fine scale 0-20,
5 pieces numbered with 0-4-8-12-16
8 Nm
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
9.6 Nm
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
