Publicidad
Idiomas disponibles
Idiomas disponibles
Decorative
Rear Trim Installation
(if required)
1. Disconnect
the power from the range.
2. Make sure the range is leveled.
3. Pull range toward you.
4. Measure the distance between the floor and the
surface underneath the cooktop frame.
5. Mark that distance on the wall where the decorative
trim will be installed.
6. Draw a line.
7. Place the top of the decorative trim under that line.
8. Using the screws provided fix the decorative trim
into the wall.
9. Slide the range back into position as far as it will go
and reconnect the 3ower source.
Trim
Distance
between
floor
and the
-..surface
underneath
the cooktop
frame.
sure that all round style burner caps are correctly in
place on round burner heads.
Check and be sure that all oval style burner caps are
correctly
in place on oval burner heads (if equipped).
Check and be sure that all dual or twin style burner caps
are correctly in place on dual or twin heads (if equipped).
On round style burners, the burner cap lip (Figure 15)
should fit snug into the center of burner head and be
level. Refer to figures 16 & 17 for correct and incorrect
burner cap placement.
Once in place, you may check the fit by gently sliding
the burner cap from side to side (Figure 18) to be sure
it is centered and firmly seated. When the burner cap lip
makes contact inside the center of the burner head you
will be able to hear the burner cap click. Please note
that the burner cap should NOT move off the center of
the burner head when sliding from side to side.
Burner Cap ....................
_""\ Burner
Burner
Cap Lip
Figure 14
|
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions
and for care and
cleaning of your range.
Remove all packaging from the oven before testing.
|
Check
Burner
Cap Placement
It is very important
to be sure that all surface burner
caps and burner grates are properly
installed
and in
the correct
locations
before
operating
the appliance.
Please
note that the burner
heads
are secured
to
the cooktop.
The cooktop
is not removable.
Do not
attempt to remove or lift the cooktop.
_To
prevent flare-ups and avoid creation
of harmful by-products,
do not use the cooktop without
all burner
caps properly
installed
to insure
proper
ignition and gas flame size.
Always keep the burner caps and burner heads in
place whenever the surface burners are in use. DO
not allow spills,
food, cleaning
agents or any other
material
to enter the gas orifice holder openings.
Check and be sure the size of each burner cap
matches the size of the burner head. Check and be
Figure 15
Correct Burner Cap
Incorrect
Burner Cap
Placement
Figure 16
-
Placement - Figure 17
Figure 1
|
Turn on Electrical
Power
and Open
Main Shutoff
Gas Valve
|
Check
the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power.
a. To check for proper lighting, push in and turn a surface
burner knob to the LITE position. You will hear the
igniter sparking.
b. The surface burner should ignite when gas is available
to the burner. Purge air from supply lines by leaving
knob in the LITE position until burner ignites. Each
burner should light within four (4) seconds in normal
operation after air has been purged from supply lines.
13
Publicidad
