VONROC SS501AC Traducción Del Manual Original página 7

• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
This scroll saw is great for making toys, puzzles,
games, fretwork and jewelry. Because of its cutting
capacity it is a handy do-it-yourself tool. It cuts
wood up to 50 mm thick as well as plastics and
non-ferrous metals.
Model No.
Voltage
Frequency
Power input
No-load speed
Blade length
Max. Cutting depth at 90°
Max. Cutting depth at 45°
Max. Cutting length/working
depth
Weight
Sound pressure (LPA)
Acoustic power (LWA)
Protection type
DESCRIPTION
The numbers in the following text refer to the pictu-
res on page 2 - 4.
1. On/off switch
2. Angle adjustment knob
3. Speed adjustment knob
4. Saw blade holder
5. Protective cover
6. Spanner
7. Dust blow pipe
8. Workpiece holder
9. Table inlay
10. Foot pedal switch
11. Connection vacuum cleaner
WWW.VONROC.COM
12. Locking knob
13. Operation switch
14. LED Work light
3. ASSEMBLY
Install of a stationary machine (Fig. B)
This machine is a stationary machine and for safety
reasons we recommend the machine to be firmly
installed and not used for mobile applications.
The machine can be mounted to a workbench as
shown on Fig. B. The machine must be mounted on
SS501AC
the same 4 points that the rubber feet are assem-
230 V ~
bled. Each of the 4 points must be secured with a
bolt, washer and nut. The necessary tools and small
50 Hz
parts for assembling the saw on a workbench are
120 W (S6 30%)
not supplied with the saw.
400 - 1600 min
-1
Installing the protective cover (Fig. C)
125mm
Before commissioning the machine, the protective
50mm
cover (5) must be installed.
23mm
• Mount the protective cover on the metal part as
406mm
• Insert the screw as shown on Fig. C.
• Screw the nut tightly.
11kg
4. OPERATION
71 dB(A) K=3dB
84 dB(A) K=3dB
Class I
Switching on/off (Fig. A)
Place the machine onto a flat and solid surface.
Place the Foot pedal switch (10) on the ground. The
machine can be switched on/off when the pedal is
actuated. A foot pedal switch for switching on/off is
practical, especially for internal cuttings, since your
hands are kept free and you can fully concentrate
on the work piece under the scroll saw. The foot
pedal switch cannot influence the speed (see
below Speed Adjustment).
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
shown on Fig. C
Always observe the safety instructions and
obey the relevant regulations.
Beware of unintentional actuation of the foot
pedal switch.
EN
7