VONROC SS501AC Traducción Del Manual Original página 9

Workpiece holder (Fig. A, H)
The workpiece holder (8) is used to hold the work-
piece to the saw table, preventing the workpiece
from moving up and down due to the movement of
the blade. The workpiece holder must be adjusted in
height depending on the thickness of the workpiece.
• Untighten the Locking knob (12) by turning it
anti-clockwise.
• Adjust the height of the Workpiece holder (8) to
the desired height.
• Retighten the Locking knob (12) by turning it
clockwise.
Speed Adjustment (Fig. A)
The required speed can be adjusted by using the
Speed adjustment knob (3). Also during running the
rotational speed can be adjusted.
• To increase the speed, turn the Speed adjust-
ment knob (3) clockwise.
• To decrease the speed, turn the Speed adjust-
ment knob (3) anti-clockwise.
The required speeds depends on the material and
can be determined by practical testing.
Sawdust blower (Fig. A)
The sawdust blower keeps the workpiece clean for
more accurate scroll cuts. For best results, always
direct air flow from the dust blow pipe at the blade
and workpiece. To adjust, simply bend to desired
position.
5. MAINTENANCE
Always disconnect the machine from the
main power supply before carrying out any
maintenance work.
The machine is designed to function faultlessly for
a long period and with a minimum of maintenance.
Extend its lifespan by regularly cleaning the machine
and treating it correctly.
Cleaning
Regularly clean the machine with a soft cloth, pref-
erably after each use. Keep the ventilator slot free
of dust and other deposits. Remove any tenacious
deposits with a soft cloth moistened with soap. Do
not use solvents (petrol, alcohol, ammonia, etc.) as
they will damage the plastic parts.
WWW.VONROC.COM
Replacing the supply cord
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
Replacing cables or plugs
Dispose of old cables or plugs immediately after
replacing them. It is dangerous to connect the plug
of a loose cable to a wall socket.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
EN
9