VONROC SS501AC Traducción Del Manual Original página 8

EN
Caution! Always choose the preferred
operation mode with the Operation switch
(13) before using the machine. The machine
will not start in 'O' mode.
Continuous operating mode
• Use the Operation switch (13) to choose for 'I'
continuous operation.
• Connect the scroll saw to the mains.
• Start the machine by pushing the green ON-
switch (1).
Push the red OFF-switch (1) to turn the machine
off.
Foot pedal operating mode
• Use the Operation switch (13) to choose for 'II'
foot pedal operation.
• Connect the scroll saw to the mains.
• Push the green ON-switch (1).
• Start the machine by pushing the Foot pedal
switch (10) with your foot.
To stop the machine, release the Foot pedal switch
(10). Push the red OFF-switch (1) to turn the ma-
chine off.
Tilting the table (Fig. A, D)
The scroll saw table can be tilted from 0 to 45°.
To do so:
• Untighten the Angle adjustment knob (2) by
turning it anti-clockwise.
• Manually tilt the table until the desired angle
has been reached (see the graduated scale on
the machine).
• Retighten the Angle adjustment knob (2) by
turning it clockwise.
Removing the saw blade (Fig. E)
Always disconnect the machine from the
main power supply before carrying out any
maintenance work.
• Untighten the Spanner (6) by turning it clock-
wise until the spring is slack.
• Pull the Table inlay (9) upwards out of the saw
table to achieve a clear view of the blade, as
shown on fig. E1.
• Carefully push down the upper saw-blade hold-
er and slightly lift the blade in order to facilitate
its removal, as shown on fig. E2.
8
• Allow the blade to drop down slightly and push
it forward, in order to loosen it from the lower
holder.
Installing the saw blade (Fig. E)
Always disconnect the machine from the
main power supply before carrying out any
maintenance work.
• Select the correct blade for the kind of wood to
be cut.
• Untighten the Spanner (6) by turning it clockwise
until the spring is slack.
• Pull the Table inlay (9) upwards out of the saw
table to achieve a clear view of the blade, as
shown on fig. E1.
• Push the saw blade through the slot, with the
teeth pointing downwards. Make sure that the
bolt of the saw blade (or saw-blade adapter)
slides into the lower saw blade holder.
• Pull the saw blade up, so that the upper bolt (or
saw-blade adapter) slides into the upper holder.
• Push the Table inlay (9) downwards into the saw
table.
• Retighten the Spanner (6) by turning it anti-
clockwise until the saw blade has the required
tension.
• Remove all tools and other objects from the saw
table. Activate the current and allow the saw
blade to run before starting to saw. The saw
blade should run quietly.
Adjusting the saw blade position (Fig. F)
The saw blade can be mounted in two different po-
sitions: regular frontal position as shown on Fig. F1
and in sideways position as shown on Fig. F2. When
using the sideways position, even longer workpieces
ca be sawed with ease.
Adapters for universal saw blades (Fig. G)
The enclosed adapters should only be used with
universal (= without pins on the end) saw blades.
• Unscrew the Allen screws on the adapter anti-
clockwise as shown on fig. G1.
• Slide the universal saw into the gap between he
Allen screws.
• Tighten the Allen screws clockwise so the saw is
clamped.
• Install the saw blade (see INSTALLING THE SAW
BLADE) on the saw blade holders as shown on
fig. G2.
WWW.VONROC.COM