Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting with Dreamehome App
EN
Scan the QR code on the robot, or search "Dreamehome" in the app store to
download and install the app.
QR Code
Note:
· Only 2.4 GHz Wi-Fi is supported.
· Due to upgrades in the app software, the actual operations may differ from
the directions in this manual. Please follow the instructions based on the
current app version.
10
2. Add Device
Open the Dreamehome app, tap " " in the upper right corner, and scan the
same QR code on the robot again to add the device. Please follow the prompts
to finish the Wi-Fi connection.
Wi-Fi Indicator
· Blinking slowly: To be connected
· Blinking quickly: Connecting
· On: Connected
Note: If you want to reset Wi-Fi, repeat step 2 and then follow the prompts
to finish the Wi-Fi connection.
How to Use
Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the charging dock, the
robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the dock and press and hold the
button for 3
seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the charging dock, the mapping process has been
completed and the map will be saved automatically.
Start Cleaning
Press the button
to start cleaning after the robot is turned on. Then, the
robot will accurately map out a route, methodically clean along the edges
and walls, then finish by cleaning each room in an S-shaped pattern to
ensure a thorough job.
Note: It is recommended that the robot set out from the charging dock
before cleaning. Do not move the charging dock while the robot is cleaning.
This ensures that the robot returns to charging dock smoothly.
Pause/Sleep
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters
sleep mode. All indicators on the robot will turn off. Press any button on the
robot, or use the app to wake up the robot.
Note: If the robot is paused and placed onto the charging dock, the current
cleaning task will end.
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the charging
dock to charge. After charging to the appropriate battery level, it will resume
unfinished cleaning tasks.
Note: To use this function, please open it in the App.
Do Not Disturb (DND) Mode
When the robot is set to Do Not Disturb (DND) mode, the robot will be prevented
from resuming cleaning and the power indicator will turn off. DND mode is
disabled by default at the factory. You can use the app to enable DND mode or
modify the DND period. The DND period is 22:00–8:00 by default.
Note:
· The scheduled cleaning tasks will be performed as usual during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press and hold the button
for 3 seconds to
enable the spot cleaning mode. In this mode, the robot cleans a square-shaped
area of 1.5 × 1.5 meters around it and returns to its starting point once the spot
cleaning is completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the button
for 10 seconds to forcefully turn it off. Then, press and hold the button
seconds to turn the robot on.
EN
for 3
11
Publicidad
