Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
Total Sweeping Width .............................................. 15.5 in.
Paddle Length ........................................................... 7.8 in.
Paddle Diameter ......................................................... 10 in.
UNPACKING
This product requires assembly.
Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Broom Attachment
J-Handle with Hardware
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
FEATURES
KNOW YOUR BROOM ATTACHMENT
See Figure 1.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety rules.
ASSEMBLY
WARNING:
Do not connect to power head until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
JOINING THE POWER HEAD TO THE BROOM
ATTACHMENT
See Figure 2.
WARNING:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine or motor could cause
serious personal injury.
The attachment connects to the power head by means of
a coupler device.
Stop the engine or motor and remove the spark plug
wire, disconnect from the power supply, or remove the
battery pack.
Remove the hanger cap from the attachment.
Loosen the knob on the coupler of the power head shaft.
Push in the button located on the attachment. Align the
button with the guide recess on the power head coupler
and slide the two shafts together. Rotate attachment shaft
until button locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
rotate from side to side until the button is locked into place.
Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
to avoid serious injury.
5 — English
Publicidad
