Publicidad
Idiomas disponibles
Idiomas disponibles
APPARTAMENTO
4
- INSTALLATION
The machine must only be installed in
places where it is easy to use and access.
The support surface must be levelled, dry,
smooth, stable and at such a height that the
base is at least 100/105 cm approx. above
the ground. (fig._4.1)
Do not use or install where water jets are
used.
In order to ensure normal operation, the
MACHINE
UNDER
MAINTENANCE
fig_4.1
machine must be installed in areas where
MACHINE
the room temperature is between +5°C and
UNDER
+36°C and humidity does not exceed 70%.
MAINTENANCE
Ensure that there is an open area of at
least 10 cm on each side and behind the
machine to allow adequate ventilation and
facilitate its use and the performance of any
maintenance operations. (fig._4.2)
52
fig_4.2
i
If the machine is wet or very
damp, wait until it is completely
dry before installing or using it.
4.1 Filling the
water tank
Make sure to use water with a
i
degree of hardness suitable for
this type of machine (see par. 3.6
page 51)
The machine has to operate with clean soft
drinking water. Never attempt to operate
the machine with water of a hardness other
than that specified in paragraph 3.6.
Lift the tank chamber cover (1 fig. 4.4) and fill
with water up to the "MAX" level indicated
(about 1,9
L). The manufacturer recom-
mends inserting a softener bag (2) in the
water tank.
fig_4.3
Publicidad
