Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING & MAINTENANCE
For performance, appearance, and health reasons, clean filter, fan and grease-laden
surfaces regularly. Use only a clean cloth and mild detergent solution on stainless and
painted surfaces.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of
the filter may occur if using phosphate detergents, or as a result of local water conditions -
but this will not affect filter performance. This discoloration is not covered by the warranty.
Clean the non-duct recirculating filter surfaces frequently with a damp cloth and a mild
detergent. DO NOT immerse filters in water or put in dishwasher. Change the non-
duct recirculating filters every 6 months. For replacement non-duct recirculating filters
- purchase S97018968 or Model AFCWTT32 (for 30" wide hood) or S97019039 or Model
AFCWTT326 (for 36" and 42" wide hoods).
The motor is permanently lubricated and never needs oiling. If the motor bearings
make excessive or unusual noise, replace the blower assembly with an exact service
replacement.
LIGHT BULBS
WARNING:
Bulbs may be hot.
Always allow bulbs
to cool down before
removing them.
Use (2) Halogen Bulbs
(included with hood) -
120 V, 50 W, shielded
halogen bulbs - MR16
with GU10 base. (3
bulbs for 42" & 48"
hoods.)
NOTE:
Suction Cup Tool
(included with hood) can be used to install and remove light bulbs. Align pins on bulb
with large diameter opening on socket, then push bulb in towards hood and rotate
clockwise until firmly seated. The position of the bulb socket (depth) is adjustable and
may require adjustment when: a) certain brands of bulbs are difficult to install. b) the
bulb protrudes too far below the light panel.
To change the depth of bulb
sockets:
- Remove screws on light
panel – set screws aside
- Remove Light Panel.
- Loosen 2 Screws holding
Lamp Socket Bracket to Light
Panel.
- Adjust socket/bracket to
desired depth.
- Re-tighten screws securely.
- Re-attach light panel with
screws that were previously
set aside.
HALOGEN
BULB
(2)
ROTATE
CLOCKWISE
LAMP SOCKET
BRACKET
LIGHT
PANEL
- 6 -
SUCTION
CUP TOOL
(1)
PUSH IN
SCREWS
Publicidad
