TESY CN04 YYZ MIS F Instrucciones Para El Uso Y Mantenimiento página 4

two securing screws. The screw goes through the plastic foot and gets
EN
screwed into plastic nut based on portable electric convector heater. You
should repeat the same operation for the second foot.
•
The joint is secure in case the portable electric convector heater stands
horizontally on the floor after its feet installation has been completed.
Do not use the power cord as a pulling rope in order to move the
portable electric convector heater; any movement of the portable electric
convector heater should be done when it is cold.
•
Position the portable electric convector heater with installed feet on
the floor and before connecting it to the power socket check if all
instructions from the very beginning of this manual have been followed
correctly (Important instructions and safety measures). The correct
position is – the control panel should be at the top of the appliance and
the feet – on the floor!
BATHROOM OPERATION
•
The portable electric convector heater must be installed in accordance
with the normal trade practices and in compliance with the national
legislation (EU electricity directives and regulations concerning special
installations and places of operation including bathrooms, shower cabins
HD60364-7-701(IEC 60364-7-701)). (fig. 3)
•
In case this portable electric convector heater is to be used in a bathroom
or other similar room, the following installation requirements must be
observed: the portable electric convector heater is with IP24 protection
(water drops protection). Hence it can be installed in "Volume 2" (see the
diagram below) in order to avoid the risk of the control board (power
switch and thermo regulator) being reached by a person who is in a
shower or a bathtub. The minimum distance between the appliance
and a water source should be not less than 1 meter! If you do not feel
sure about the installation of this portable electric convector heater in
a bathroom, we recommend you to consult a professional electrician.
Note: If the above-mentioned instructions cannot be implemented, it is
recommended to install the appliance in "VOLUME 3".
•
In wet premises the power source must be installed at a height of at least 25
cm above the floor (bathrooms and kitchens).
•
The installation must be equipped with a safety fuse, and the distance between
the fuse contacts in disconnected condition should be at least 3 mm.
Thank you for choosing CN04 portable electric convector heater. This is a product
providing heating in winter depending on the consumers' needs for comfortable
room temperature. If operated and taken care of properly in accordance with
these instructions, the appliance will provide you with many years of useful
operation.
OPERATION INSTRUCTIONS
MECHANICAL CONTROL
Operation modes
Turn the portable electric convector heater on by pushing the switch in position
"I" (turned-on ), then turn the regulator to the desired level (1 to 6) as you take
into account the following relation between the power levels: (fig. 4)
* – anti-freezing mode/ enabled when room temperature falls below 7°C
1 / 2 – economy mode/ it maintains low room temperature/ this mode is
recommended to be used at night and when there are no people present in the
room. This mode permits to maintain the set room temperature while saving
energy.
3 / 4 / 5 – comfort mode/ it maintains moderate room temperature/ this mode
is recommended to be used to maintain relatively high comfortable room
temperature during the day.
6 – maximum power mode / it maintains HIGH room temperature/ this mode
is recommended to be used when you need maximum high room temperature
Important: Thermo Regulator digits do not correspond to certain room
temperature levels, but they can be used by users to memorize the relation
between room temperature and the thermo regulator settings. For fine adjustment
you can use thermometer- as you follow the principle of room temperature
measurement for a few hours (it is set according to the size of the heated premises).
When the room temperature is lower than the temperature that you have set by
the thermo regulator, the portable electric convector heater starts its operation
and will operate until the room temperature reaches the set temperature level of
the unit. When the room temperature is higher than the adjusted temperature
of the appliance, the portable electric convector heater will automatically go
into "Stand by" mode.
PROTECTION
•
The appliance is equipped with a safety thermo turn-off device, which
4
Operation and Storage Manual of Portable Electric Convector Heater
automatically turns the heater off in cases of extreme temperature of
the portable electric convector heater/i.e. overheating of the appliance/.
•
The safety thermo turn-off device will automatically restore the heater
operation when the temperature of the appliance falls below the
permissible ultimate values.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance
automatically when the heater falls over, or is at an excessive angle from the
horizontal. This helps prevent accidents, and the heater will back to last set
mode when it is put back upright.
CLEANING
•
It is compulsory first to turn off the appliance through its power switch
and to disconnect it from the power socket. Before starting the cleaning
session you should wait until the portable electric convector heater cools
down in a disconnected state.
•
Clean the heater body with damp cloth, vacuum cleaner or a brush.
•
Never immerse the appliance into water – there is danger for your life
from electric shock!
•
Never use gasoline, thinner or hard abrasive products to clean the
appliance, because they will damage the appliance coating.
STORAGE
•
Before putting the portable electric convector heater away let it cool down
after you have disconnected it from the power socket
•
Use the appliance original packing to store it, if the portable electric
convector heater will not be in use for a long period of time. By storing the
product in its original packing you protect it from excessive dirt and dust
accumulation.
•
Never put a hot portable electric convector heater in its packing!
•
It is necessary the product to be stored at a dry and dark place, protected
from direct sun light.
•
It is explicitly forbidden to store the portable electric convector heater in
damp and wet premises.
MAINTENANCE OPERATIONS OF THE APPLIANCE
•
In case of appliance malfunction, please contact the authorized
service center closest to your location. /service centers are indicated in
appliance warranty documents/.
•
Important: In case of a claim and/or violation of your consumer rights,
please contact the supplier of this appliance at the indicated locations
or via the Internet page of the company: www.tesy.com
Environment protection instructions
Obsolete electric appliances contain valuable materials and consequently they
should not be treated as domestic waste! We ask for your cooperation and your active
contribution to protect the resources and the environment. Please submit your out-
of-use appliances to the organized buy-back stations (if there are such).