Initial startup
Adjusting the push handle
Note
When the device is delivered, the push handle is folded
down. It can be adjusted to 3 different heights for work.
1. Fold the push handle up into the desired position. Make
sure that the grooves engage correctly in the bolts (fixa-
tion).
2. Tighten the star screws hand-tight.
Opening/closing the cover
CAUTION
Danger of crushing if your fingers are jammed
To open and close the device cover, only grasp the re-
cessed grip provided.
ATTENTION
Risk of burns from the hot drive motor
The drive motor can get hot during operation.
Do not touch hot surfaces. Pay attention to the warning
symbols.
Note
It is necessary to open the cover:
● for service and cleaning work
● for changing/cleaning the dust filter and pre-filter
● for storing a replacement battery.
1. Open the cover: Grab the cover by the recessed grip
and slowly swivel it all the way forward. A strap holds the
cover.
2. Closing the cover: Slowly swivel the cover back.
Mount the side brush
The side brush is supplied with the device and must be at-
tached to the device before initial startup.
See chapter "Changing the side brush".
Charge/insert battery
Charge the battery before initial startup.
Please read the information on charging and operation in
the operating instructions and safety instructions supplied
with the battery pack and charger.
1 Insert the charged battery into the battery holder, slide it
in as far as it will go and click into place.
A dust bag can be inserted into the waste container for
easy and safe disposal of the waste.
1. Operate the lock of the waste container (pull it back-
wards).
2. Tilt the waste container backwards and pull it out.
3. Fold the fastening clamps on the front of the waste con-
tainer outward.
4. Place the dust bag in the waste container and put it over
the edge.
5. Close the fastening clamp again.
6. Insert the waste container and push it all the way to the
front.
7. Check whether the waste container is engaged.
English
Dust bag (option)
7