LAVAZZA IDOLA Instrucciones De Uso página 48

EN I T
COFFEE DOSE PROGRAMMING
Doses can be programmed from machine serial num-
ber 1907S001023833 onwards. The machine serial
number is shown below the barcode on the label put
under the machine.
Measures are always programmed using the same button;
any action by pressing other buttons will be ignored.
The programmed amount of brewed coffee can be
changed by repeating the programming.
Press the ON/STAND-BY button
machine on. The machine will be ready when the ON/
STAND-BY button
button lights are steadily.
Lift the pod loading lever until it locks into position to
open the pod fitting compartment.
Put a Lavazza
ting compartment.
Lower the pod loading lever to close the pod fitting
compartment. Place the cup onto the plate.
PROGRAMMING
to switch the
stops blinking and the supply
capsule into the capsule fit-
Press down the button of the icon you wish to program.
The machine will start supplying and, after approximately
3 seconds, the other coffee buttons will start blinking
and the machine will beep
gramming mode has been accessed.
Keep the supply button depressed
Once the desired amount of coffee has been obtained,
stop supply by releasing the button.
The machine will stop and the dose will be programmed
If the programmed measure exceeds the maximum al-
lowed the machine will automatically stop delivery, the de-
livery button will blink and the last programmed measure
will be saved in the memory.
If there is a power failure during programming, the last
programmed value remains in the memory.
If during a dose programming, water lack
the machine stops the supply and the dose being pro-
grammed won't be saved. Once filled the water tank, re-
peat the dose programming procedure.
48
, to indicate that the pro-
is indicated,