The cycle will be temporarily interrupted when the fluid
runs out in the machine tank.
DO NOT top up the tank during this phase.
You must allow the tank to empty completely.
Empty the container used to collect the solution.
ON/STAND-BY
, LONG COFFEE button
"No water" warning lamp
Descaling warning lamp
Remove the water tank, rinse and wash it accurately.
Fill it with drinking fresh non-carbonated water up to the
MAX. level.
In case of power supply interruption, the machine will,
upon the first power-on, resume the rinse procedure
where it was interrupted: press the LONG COFFEE
button
to restart RINSING.
Fit the tank with water. Place a container with a capacity
of at least 0.5 litres under the supply device.
MAINTENANCE AND CLEANING
and
will be ON to a steady light.
will be ON and blinking.
Press the LONG COFFEE button
cycle.
At the end of the first rinse cycle, refill the water tank
and start the second rinse cycle by pressing the LONG
COFFEE button
To end the rinse cycle, a minimum amount of water of
67.62 fl oz (2 litres) (approximately 2 tanks)
to be supplied.
In case of lack of water, the cycle will be temporarily inter-
rupted, the machine will emit a prolonged acoustic signal
(if enabled) and the "No water
come on to a steady light.
Top up the tank and press the LONG COFFEE button
again to restart the rinse cycle
At rinse end, the descaling warning lamp goes off, which
confirms that the procedure has come to an end.
Before using the machine, empty and thoroughly rinse
the milk frothing jug and its cover, clean it using a soft
moist cloth.
53
to start he rinsing
.
" warning lamp will
E N
will have