Descargar Imprimir esta página

Bosch CS20 Instrucciones De Funcionamiento Y Seguridad página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

POCKET
CUTS
Disconnect
the plug from the power
source
before making
adjustments.
Set depth adjust-
ment according
to material to be cut. Tilt saw
forward with cutting
guide notch lined up with
the line you've drawn. Raise the lower guard,
using lift lever and hold the saw by the front and
rear handles (Fig. 8).
With the blade just clearing the material to be
cut, start the motor. Gradually
lower the back
end of saw using the front end of the foot as the
hinge point.
I_i_1
As blade
starts
cutting
the
material,
release
the lower
guard immediately.
When the foot rests flat on
the surface being cut, proceed cutting in forward
direction to end of cut.
I_i_1
Allow
blade
to come
to a
complete
stop
before lifting
the saw from
cut. Also,
never
pull the saw
backward
since
blade
will climb
out of the
material and KICKBACK
will occur.
Turn saw around and finish the cut in the
normal manner, sawing forward. If corners of
your pocket cut are not completely cut through,
use a jigsaw or hand saw to finish the corners.
FOOT
2/
ii>"
LOWER
GUARD
LIFT LEVER
LINE GUIDE
CUTTING
LARGE SHEETS
Large sheets
and long boards
sag or bend,
depending
on support.
If you attempt
to cut
without
leveling
and properly
supporting
the
piece, the blade will tend to bind, causing KICK-
BACK
and
extra
load
on
the
motor
(Fig. 9).
Support the panel or board close to the cut, as
shown in (Fig. 10). Be sure to set the depth of
the cut so that you cut through
the sheet or
WRONG
board only and not the table or work bench. The
two-by-fours
used to raise and support the work
should be positioned so that the broadest sides
support the work and rest on the table or bench.
Do not support the work with the narrow sides
as this is an unsteady arrangement.
If the sheet
or board to be cut is too large for a table or work
bench, use the supporting
two-by-fours
on the
floor and secure.
-12-
RIGHT

Publicidad

loading