Saunier Duval SDH 10-020 MCNHWI Manual De Usuario página 81

7- INDICATORS ON THE DISPLAY OF REMOTE CONTROL
Setting the clock
CLOCK SET TE
FAN SPEED
Initial setting of the clock
After inserting the batteries into the remote control, the time indicator will display "1:00". Press
CLOCK button and it will begin to flash.
Then, use the bottons TEMP/TIME
5
Increase
6
Decrease
Each time one of these buttons is pressed and released again after a moment, the time indicator
increases or decreases by one minute, depending which button is pressed.
The time indicator changes as fast as the button is repeatedly pressed.
As long as one of these buttons is pressed and kept down pressed, the time indicator increases
or decreases in steps of 10 minutes, depending which button is pressed.
Before starting the air conditioner operation, set the clock
to the current time at the remote control according to the
following instructions. The time indicator on the display of
the remote control will show the time either the air con-
ditioner is in operation or not.
5 6
to set the current time
9 9