Saunier Duval SDH 10-020 MCNHWI Manual De Usuario página 84

7- INDICATORS ON THE DISPLAY OF REMOTE CONTROL
7.3- COOLING / HEATING / "FAN ONLY" OPERATION
CLOCK SET TE
5
6
FAN SPEED
7.4- DRYING OPERATION
5
6
CLOCK SET TE
FAN SPEED
NOTE
During AUTO and DRY mode the fan speed can not be adjusted.
Start
Ensure the unit is plugged and electric power is available.
The operation indicator on the display panel of the indoor
unit starts flashing.
1. Press MODE button until COOL, HEAT, or FAN ONLY
mode is selected.
. Use TEMP/TIME button to select the desired tem-
perature. The most comfortable temperature is 1°C
– 8°C.
. Press the FAN SPEED button to select AUTO, LOW, MED,
or HIGH mode for the fan speed.
4. If the ON/OFF indicator on the display is switched OFF,
press the ON/OFF button to start the air conditioner.
Stop
1. Press the ON/OFF button again to stop the air con-
ditioner operation.
During FAN ONLY mode the temperature is not
controlled. Therefore only perform the above steps 1, ,
and 4 if you want to select the FAN ONLY mode.
Start
Ensure the unit is plugged and electric power is available.
The operation indicator on the display panel of the indoor
unit starts flashing.
1. Press MODE button until DRY mode is selected.
. Use TEMP/TIME button to select the desired tempe-
rature.
. If the ON/OFF indicator on the display is switched OFF,
press the ON/OFF button to start the air conditioner.
Stop
1. Press the ON/OFF button again to stop the air con-
ditioner operation.
1 1