cecotec Conga THUNDERBRUSH 620 Manual De Instrucciones página 14

ENGLISH
Dust tank installation
1. Holding the main body by the handle with one hand,
align it with the dust tank and then turn the dust tank
anticlockwise until a click is heard, indicating it is
properly fixed.
2. To remove it, turn it clockwise.
Accessories installation
1. Remove the aspiration base as it is explained in the
section before, select the desired accessory and
insert in the aluminium hose's end. A click will be
heard indicating it is properly fixed in its place.
2. To remove any accessory, pull from it.
Unit charging
1. Connect the power adapter to the vacuum cleaner and to the power supply.
2. The light indicator will blink during charging and will turn steady when the charge is
completed.
3. It is not suggested to use the vacuum cleaner during the charging process.
WARNING: the battery provided is the only one suitable for the vacuum cleaner.
4. OPERATION
1. Place the appropriate accessory on the aluminium hose's end.
2. Press the ECO button located next to the handle for the appliance to operate at low
consume.
3. Press the power button located next to the handle for the appliance to operate at
maximum power and press again to stop operation.
NOTE: the light indicator will turn on during operation.
5. CLEANING AND MAINTENANCE
Dust tank
• Press the dust tank release button to open the dust tank.
• Place the dust tank above the bin and gently shake it in order to empty all the dust.
• Remove the dust tank by turning it anticlockwise and wash it with water if necessary.
• Dry thoroughly the dust tank before inserting it back again in its place.
14
CONGA THUNDERBRUSH 620 IMMORTAL BATTERY 22.2 V
05115 ThunderBrush 620_MV.indd 14 25/7/18 22:54