Technical Characteristics - Bras Is-Cream Manual De Instrucciones

EN GLIS H
I s - C r e a m
1 ELECTRICAL SAFETY INSTRUCTIONS
1 Before connecting the dispenser to the mains, check that
the voltage shown on the rating plate matches your electricity
supply. Connect the dispenser to a single-phase supply
through an earthed socket as required by current regulations. If
the dispenser is to be disconnected from the power supply
using a single pole switch, the gap between the contacts on this
switch must be sufficiently wide to guarantee full disconnection
under category III overload conditions.?
2 Do not use extension cables to connect the appliance.
3 To avoid any risks, if the power cable is damaged, it must
be replaced by the manufacturer, by an authorised technician
or by a similarly qualified person.
4 The dispenser is not suitable for outdoor use.
5 The dispenser must be installed in the upright position.
6 Before cleaning, always disconnect the dispenser by
removing the plug from the socket.
7 Always disconnect the dispenser before removing any of
the panels for cleaning or maintenance work.
8 Do not use a water jet to clean the dispenser.
9 This appliance must not be operated by children.
10 Do not let children play with the appliance.
11 This appliance must not be used by persons with reduced
physical, sensory or mental capabilities or with a lack of
experience and knowledge unless they have supervision or
have been trained regarding the safe use of the appliance and
understand the risks involved.
12 Only persons who know and have practical experience of
the appliance are permitted access to the inner components of
the dispenser, especially when dealing with issues regarding
safety and hygiene.
2 HYGIENIC SAFETY INSTRUCTIONS
1 This appliance is intended exclusively for domestic and
similar use.
2 For the appliance to operate correctly, room temperature
must be between +5° and +32°C.
3 Use the appliance to cool the indicated liquids only.
4 Do not introduce dangerous or toxic liquids to the appliance.

3 TECHNICAL CHARACTERISTICS

Bowl capacity, approx
Evaporator capacity, approx
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Hermetic compressor
Air-cooled condenser
Overload protector
Noise level lower than 70 dB (A)
IMPORTANT
Electrical characteristics: read the data featured on the
data plate of each dispenser; this data plate is situated in
the lower part of the front panel, behind the drip tray. The
serial numbers of appliances (preceded by the symbol #)
are indicated on the frame, at the rear of the appliance,
behind the condenser cover panel. The data specified on
the data plate are always those you should refer to.
The manufacturer reserves the right to amend this manual
without notice.
4 INTRODUCTION
Read this instruction manual carefully to find out all the
characteristics of the dispenser.
As with all mechanical products, this dispenser also requires
cleaning and care. In addition, its correct operation may be
compromised by possible errors made by the operator during
the disassembly and cleaning operations. For this reason, it is
important that the disassembly, cleaning, sanitising and
reassembly procedures - being everyday tasks - are familiar,
without any room for error on the part of the dispenser user.
5 INSTALLATION
1 Take the dispenser out of its packaging, which we
recommend you keep for future requirements.
2 Make sure that the dispenser has not been damaged during
transportation. If this is the case, immediately make a claim
with your carrier.
3 Place the dispenser onto a counter designed to withstand
its weight, including when full.
4 Leave a clearance of at least 15 cm around the whole
dispenser to avoid obstructing the cooling air flow.
5 Check the stability of the appliance and adjust the height of
the feet if necessary. Should the dispenser be supplied with a
series of high feet (100 mm approx.), replace the originals with
14
l 4
l 2
cm 26
cm 57
cm 72
kg 50
kg 55