Touch Display - Bras Is-Cream Manual De Instrucciones

switched on and in stand-by mode, ready for operation. Hold
down key P for one second to switch the dispenser on and off.

TOUCH DISPLAY

The following icons appear on the display:
A ICE CREAM PRODUCTION icon; when pressed, it
enables the ICE CREAM function.
B CONSERVATION icon; when pressed, it enables the
CONSERVATION function.
C WASHING icon; when pressed, it enables the WASHING
function.
D PARAMETERS icon; when pressed, it enables the adjust-
ment of the operating PARAMETERS.
E Alarm code. Indicates the presence of an alarm and the re-
levant code.
F Density bar. Indicates the density level set.
G Mixture temperature. Indicates the temperature of the mix-
ture in the upper tank.
H Status icon. Indicates the status of the dispenser (ice cre-
am, conservation, washing, alarm) and the ice cream pre-
paration status when the ice cream mode has been
enabled:
red icon: ice cream not ready
yellow icon: ice cream almost ready
green icon: ice cream ready
I Upper tank cooling icon. Indicates that the upper tank co-
oling is in operation.
J Lower cylinder cooling icon. Indicates that the lower cylin-
der cooling is in operation.
K Compressor icon. Indicates the cooling compressor is in
operation.
L Display shut-down icon. Indicates that the touch display
has shut down and no controls can be entered.
FOR DISPENSER OPERATION
Set the main switch to position I. Red indicator light Q comes on.
Hold down key P until the dispenser starts up again.
Select the desired function using icons A, B, c or D.
ICE CREAM MODE
In this operating mode, the machine produces ice cream and the
mixture in the upper tank is kept at a suitable temperature to
preserve it. The ice cream preparation status is indicated on the
display by the central icon and by the colour of the arrows.(see
figure 8
figure 9)
When the ice cream is ready, the mixing system slows down, the
cooling system stops and the appliance switches to awaiting to
dispense mode. At default intervals (factory set to every 10
minutes), the mixing system increases the speed and the
cooling system is started to restore the proper ice cream
density.
When the dispensing tap is opened, the mixing system
increases its speed and the cooling system is enabled.
In order to produce ice cream, the upper tank must contain a
suitable quantity of mixture. If this is not the case, the cooling
system is not started and the display indicates the icon for low
product.(see figure 10)
Density adjustment
The density of the ice cream can be adjusted on a scale of 1 to
10. To make this adjustment, you need to touch the graduated
bar situated on the right-hand side of the display and enter
density mode. The following controls are available:
A Exit icon: to exit this mode without making any changes.
B Decrease icon: to decrease the value set.
C Increase icon: to increase the value set.
D Confirm icon: to confirm the value set.
(see figure 11)
CONSERVATION MODE
17
figure 9
figure 10
figure 11