To Operate Safely; Operating Procedures - Bras Is-Cream Manual De Instrucciones

these.
ATTENTION
Make sure the appliance is earthed correctly; if this is not
the case, this may cause electric shocks to people or
damage to the dispenser.
6 The dispenser is not supplied pre-cleaned and sanitised by
the factory. Before use, it must be disassembled, cleaned and
sanitised according to the instructions provided herein in
chapter 7.4 CLEANING.
IMPORTANT
Position the appliance in such a way that the power sup-
ply cable plug is easily accessible.

6 TO OPERATE SAFELY

1 Do not use the dispenser before reading this instruction
manual first.
2 Do not use the dispenser unless it is earthed correctly.
3 Do not operate the dispenser if the panels are not in place
and secured with screws.
4 Do not insert your fingers or objects into the panel slits or in
the tap orifice.
5 Do not remove parts or panels for cleaning or maintenance
without first making sure the dispenser is disconnected from
the electricity supply.
6 The cover must remain closed at all times.

7 OPERATING PROCEDURES

IMPORTANT
Before use, clean and sanitise the dispenser according
to the instructions provided herein in chapter 7.4.2 CLE-
ANING.
IMPORTANT
If the tap assembly has not been installed, the appliance
cannot operate and the display shows the tap assembly
open icon (see figure 1).
This appliance is equipped with an upper tank designed to keep
figure 1
the ice-cream preparation base refrigerated and a lower cylinder
for the production of the ice cream.
Every time a portion of ice cream is dispensed, the same
quantity of ice cream mixture drops down by the force of gravity
from the upper tank into the lower cylinder.
In order to obtain softer and lighter ice cream, make sure that a
certain quantity of air enters the cylinder together with the
mixture. To this end, the machine is equipped with a purpose-
designed two-part mixing pipe. (see figure 2)
For best results, the following steps must be performed in the
order specified:
1 Insert the lower part of the mixing pipe into the purpose-
provided connection slot between the tank and the cylinder,
making sure you direct it in such a way as to insert it fully in its
seat. (see figure 3)
2 Pour the mixture into the upper tank and wait for the
cylinder to fill up. This will occur when no more air bubbles exit
the holes in the mixing pipe. (see figure 4)
15
figure 2
figure 3
figure 4