Publicidad
Idiomas disponibles
Idiomas disponibles
3.4
Starting current limiter
The electronic starting current limiter reduces the starting current drawn to prevent the line fuse from tripping.
This prevents abrupt start-up of the product.
3.5
Constant-speed electronics
Electronic speed control keeps running speed almost constant irrespective of whether the power tool is
idling or running under load. Constant running speed helps ensure maximum efficiency.
3.6
3D Active Torque Control (
The product has 3D Active Torque Control (
If it detects a sudden, unforeseen movement in operation, the product automatically shuts down immediately.
If
3D
ATC has tripped, switch the product off and then on again.
3.7
Restart interlock
The product does not restart by itself when the on/off switch is locked in the ON position and power is restored
after an interruption in the electric supply. The on/off switch must first be released and then pressed again.
3.8
Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current draw and motor temperature to
prevent the product from overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely. A standstill should be avoided. The product's permissible
overload depends on motor temperature and is not a specific value.
3.9
Integrated brake
The integrated brake reduces the time it takes until the accessory tool stops rotating after switching off.
This functions correctly only as long as the product is supplied with electric current.
Braking time varies, depending on the selected accessory tool.
3.10
Front cover
2
Use the standard guard with front cover for the applications listed below:
•
Grinding with straight grinding wheels
•
Cutting with cut-off wheels
3.11
DG-EX dust hood for grinding (accessory)
The grinding system is suitable only for occasional use with diamond cup wheels for grinding mineral
materials.
Use of this guard for working on metal is not permissible.
The dust hood is suitable only for accessory tools with a diameter of max. 125 mm (5").
3.12
DC-EX 150/6"C compact dust hood for cutting (accessory)
Use the DC-EX 150/6"C compact hood when working on mineral materials and for the following jobs:
•
Cutting with diamond cut-off wheels
Use of this guard for working on metal is not permissible.
The dust hood is suitable only for accessory tools with a diameter of max. 150 mm (6").
8
English
3D
ATC )
3D
ATC).
3
4
2381083
*2381083*
Publicidad
