Publicidad
Idiomas disponibles
Idiomas disponibles
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
7.1
Switching on
12
WARNING
Risk of injury. The accessory tool may suddenly stick or stall.
▶ Use the product with the side handle fitted and always hold the product securely with both hands.
The on/off switch with built-in switch-on interlock gives the user full control of the switch function and
prevents unintentional starting.
1. Plug the supply cord into the power outlet.
2. Push the switch-on interlock forward to unlock the on/off switch.
3. Fully depress the on/off switch.
▶ The motor runs.
7.2
Grinding
Do not allow the accessory tool to jam and avoid excessive pressure on the product.
7.3
Cutting
▶ When cutting, keep the rate of advance moderate and do not tilt the product or the cut-off wheel to either
side (working position is at approx. 90° to the cutting plane).
For best results when cutting profiles and small rectangular tube, start cutting with the cut-off
wheel at the smallest cross-section.
7.4
Rough grinding
▶ Move the product to and fro while maintaining a 5° to 30° angle of attack and applying moderate pressure.
▶ This will avoid overheating and discoloration of the workpiece and help ensure an even surface finish.
7.5
Switching off
▶ Release the on/off switch.
▶ The switch-on interlock jumps automatically back to the locked position and the motor stops.
8
Care of the product
DANGER
Electric shock due to breakdown of protective insulation. When working on metal under extreme
conditions, conductive dust may accumulate inside the power tool, thereby adversely affecting the protective
insulation.
▶ Use a stationary dust extraction system when working under extreme conditions.
▶ Clean the air vents frequently.
▶ Connect a portable residual current device (GFCI) with a maximum trip current of 30 mA between the
power tool and the power source.
WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not allow foreign objects to enter the interior of the product.
▶ Keep the product, especially its gripping surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
14
English
2381083
*2381083*
Publicidad
